Athena GET RX1 PRO Handbuch Seite 9

PROCEDURE A
- For MY 2021 or more recent motorcycles;
- RX1PRO FW.CODE equal to or higher than RX1PRO14.
1.
Remove the protective
caps and connect the
RESET TPS cable (included
in the box) to RX1 PRO ECU
"MAIN" connector.
2.
Connect
charged 12V battery to
"RESET TPS" cable: first,
red wire to positive pole
(+) and then black wire to
negative pole (-).
3.
Twist the throttle
completely forward to
make sure it is in closed
position
operation.
Press and
engine stop button for 5
seconds or until the RX1
turns the fuel pump and
the MIL
Indicator Lamp) light on
(when present).
By doing this operation,
the minimum TPS value
is saved.
a fully
during this
hold the
(Malfunction
2
9
1
5 sec.
EN