Athena GET RX1 PRO Handbuch Seite 7

2.
Connect MAP Switch
faston terminals to the
MAP Switch expansion
cable faston terminals.
3.
Remove the protective
caps and connect the
Map switch expansion
cable to the GET RX1 Pro
EXP connector.
ATTENTION: After the installation, check that the
wiring does not obstruct the free movement of
the handlebar in both directions or interfere with
the moving components of the motorcycle (e.g.,
transmission) or with the rider (e.g., the boot area).
WIFI-COM INSTALLATION
Install the Wifi-COM (if included in GET RX1 Pro kit) by
following the dedicated manual.
E. ZERO TPS CALIBRATION
Zero TPS Calibration allows the ECU to properly recognize when
the throttle is completely closed, and to ensure accurate readings
of the fuel level injected into the combustion chamber. When
installing a new ECU or other accessories, such as a second injector,
GET recommends carrying out the Zero TPS Calibration. This
calibration will ensure a correct fuel calculation, so the motorbike
can accelerate accurately and will avoid poor fuel economy.
ATTENTION: The minimum and maximum TPS values are
saved if similar to the OE ones, otherwise RX1PRO will
discard the values because it will read them as incorrect.
MAP
SWITCH
7
RX1
EN