Attaching The Accessories; Start Up; Electrical Connection; Water Connection - Kärcher HD 5/11 C Originalbetriebsanleitung

Attaching the Accessories

Mount the nozzle on the spray pipe (mark-
ings on the adjustment ring at the top).
Connect ray tube to hand spray gun
Note
Only with HD 7/10 CXF:
When space is limited, the enclosed adapt-
er with nozzle can be mounted directly to
the hand spray gun.
In devices without hose drum:
Loosen the clamps of the pushing handle.
Adjust the handle to the desired height.
Tighten the clamps of the pushing handle.
Fasten the high pressure hose to the
high pressure connection.
In devices without hose drum:
Insert the crank in the hose drum shaft
and lock it in.
Before rolling up, stretch out the high
pressure hose.
Wind the high pressure hose in uniform
layers on the hose drum by rotating the
crank. Select the rotation direction in
such a way that the high pressure hose
does not get bent.

Start up

Electrical connection

Danger
Danger of injury by electric shock.
The appliance may only be connected to al-
ternating current.
The appliance may only be connected to an
electrical supply which has been installed in
accordance with IEC 60364.
The voltage indicated on the type plate
must correspond to the voltage of the elec-
trical source.
The minimum fuse rating required at the
socket outlet is (see technical specifica-
tions).
The highest allowed net impedance at the
electrical connection point (refer to techni-
cal data) is not to be exceeded. In case of
confusion regarding the power impedance
present on your connection, please contact
your utilities provider.
The appliance should always be connected to
the electrical mains using a plug. It is forbidden
to permanently connect the appliance to the
power supply. The plug is only for mains sepa-
ration.
Check the power cord with mains plug for dam-
age before every use. If the power cord is dam-
aged, please arrange immediately for the
exchange by an authorized customer service or
a skilled electrician.
The plug and coupling of the extension cable
used must be watertight.
Use the extension cord that has an adequate
cross-section (see "Technical Data") and un-
wind it fully from the cable drum.
Unsuitable extension cables can be hazardous.
Only use extension cables outdoors which
have been approved for this purpose and la-
belled with a sufficient cable cross section:
For connection values, see type plate/tech-
nical data.

Water connection

Connection to the water supply
Warning
Observe regulations of water supplier.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
For connection values refer to technical
specifications
Connect the supply hose(minimu length 7.5
m, minimum diameter 1/2") to the water
connection point of the machine and at the
water supply point (for e.g. a tap).
– 3
EN 21