Operation - Kärcher HD 5/11 C Originalbetriebsanleitung

Note
The supply hose is not included.
Open the water supply.
Drawing in water from open reservoirs
Screw the suction hose with filter (order
no. 4.440-238.0) to the water connec-
tion.
Deaerate the appliance:
Unscrew the nozzle.
Switch on the appliance and let it run
until the water exiting is bubble-free.
At the end let the appliance run for ap-
prox. 10 seconds - then switch off. Re-
peat the procedure for a couple of
times.
Switch off the appliance and fit the noz-
zle again.

Operation

Danger
Risk of explosion!
Do not spray flammable liquids.
If the appliance is used in hazardous areas
(e.g. filling stations) the corresponding
safety provisions must be observed.
Caution
Clean engines only at places with corre-
sponding oil separators (environmental
safety).
Risk of blocking. Place the nozzles in the
accessory compartment with their joint
pointing upward.
High pressure operation
Note
The appliance is equipped with a pressure
switch. The motor starts up only when the
lever of the pistol is pulled.
Roll off the high pressure hose totally
from the hose drum.
Set the appliance switch to "I".
Unlock the hand-spray gun and pull the
lever of the gun.
Set working pressure and flow rate
through turning (rungless) at the pres-
sure- and amount regulation (B) (+/-).
22
Select spray type
Close the hand spray gun.
Turn the casing of the nozzle till the de-
sired symbol matches the marking.
Flat low pressure spray
(CHEM) for operating using
detergents or cleaning at low
pressure.
High pressure flat spray (25°)
for large dirt areas
Operation with detergent
Warning
Unsuitable detergents can cause damage
to the appliance and to the object to be
cleaned. Use only those detergents that
have been approved by Kärcher. Observe
the dosage and other instructions provided
with these detergents. For considerate
treatment of the environment use detergent
economically.
Follow the safety instructions for using de-
tergents.
Kärcher detergents ensure smooth func-
tioning. Please consult us or ask for our
catalogue or our detergent information
sheets.
Take out detergent suck hose.
Suspend end of suction hose in a con-
tainer filled with detergent.
Set nozzle to "CHEM".
Set dosing value for detergent to the
desired concentration.
Recommended cleaning method
Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
Spray off loosened dirt with the high-
pressure ray.
After operations, dip the filter in clear
water. Turn the dosing valve to the
highest detergent concentration. Start
the appliance and rinse for one minute.
– 4
EN