Before Startup - Kärcher K 3.600 Originalbetriebsanleitung

Illustrations on fold-out page!
1 Coupling element for water
connection
2 High pressure hose
3 Quick coupling for high pressure hose
4 Water connection with integrated sieve
5 Appliance switch "0/OFF"/ „I/ON"
6 Dosage regulator for detergent
7 Storage for trigger gun
8 Transport handle, detachable
9 Storage for high-pressure hose
10 Storage of Plug 'n' Clean detergent bot-
tle with detergent connection
11 Storage for accessories
12 Storage hook for mains connection cable*
13 Plug 'n' Clean detergent bottle with
locking lid
14 Mains cable with mains plug
15 Wheels
16 Trigger gun
17 Lock trigger gun
18 Key to detach the high pressure hose
from the trigger gun
19 Spray lance with pressure regulation
(Vario Power)
20 Spray lance with Dirtblaster
21 Washing brush*
22 Rotary washing brush*
23 Delta-Racer D150*
* depending on model
Special accessories
Special accessories expand the possibilities
of using your appliance. Please contact your
KÄRCHER dealer for further information.

Before Startup

Mount loose parts delivered with appliance
prior to start-up.
Install wheels
 Illustration
Push the wheels into the intake and se-
cure with the enclosed plugs, watch for
positioning of plug.
Install the storage for hand-spray gun
 Illustration
Place the bottom holder into the recesses
and push forward until it audibly locks in.
Insert the top holder and push down all
the way.
Install the storage hook for the mains
connection cable
 Illustration
Press in the storage hook and lock it
into the top position.
Install the transport handle
 Illustration
Place the transport handle into the in-
take until you feel resistance. Use the
heel of your hand or a soft rubber mallet
to position it.
Install the dosage regulator for detergent
You will need the 2 included screws as well
as a Philips screwdriver PH 2.
 Illustration
Insert both detergent hoses onto the
hose fittings.
Install the dosage regulator and con-
nect using 2 screws.
Note: During installation you must
make sure that the tongues of the dos-
age regulator match up with the intend-
ed recesses in the casing.
Connect the high pressure hose to the
hand spray gun
 Illustration
Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
Check the secure connection by pulling
on the high pressure hose.
– 4
EN 17