Perform Overall Function Test - IFM Electronic efector250 Bedienungsanleitung

All manuals and user guides at all-guides.com

Perform overall function test

In this dialogue page you can test all settings which have been made.
In the Test mode an image is captured and evaluated with each triggering or by acti-
vating the Trigger button. Status and result of the evaluation are shown in the out-
put window and in the image field a red or green "traffic light" appears for the result
FAIL or PASS. The switching outputs of the sensor are set accordingly and the result
of the evaluation is indicated via a yellow LED for PASS and a red LED for FAIL.
To position other test samples you can select the Observe without testing mode. The
image will be updated continuously, there will be no evaluation.
After completion of the overall test activate the Next > button.
Then you will be asked via a dialogue window if the parameter set which has been
created or edited is to be stored.
Then continue to the Manage configuration data dialogue page. The newly created
or edited and stored parameter set was automatically activated and is marked accord-
ingly in the list of configured data files.
Monitor
You can now change into the monitor mode via the button or disconnect
the sensor in the operating program via the Disconnect sensor menu item in the
35