Monitor Sensor; Service Mode - IFM Electronic efector250 Bedienungsanleitung

Connection menu. In the latter case the sensor will be set into its usual operating
state and will work according to the settings of the active configuration data file.

Monitor sensor

In this mode the operation of the sensor can be monitored. The reference image of
the parameterisation is shown in the image field. The detected contours are shown
with each triggering. The result of the evaluation, the number of errors and statisti-
cal information are displayed in the output window.
Info
In this mode text information and the detected contours have to be transmitted from the sen-
sor to the operating program. This takes time. As compared to operation without operating
program the sensor will therefore only achieve a reduced evaluation rate.
For the diagnosis of problems with the evaluation you can change into the

Service mode

dialogue page via the
Continue to the Manage configuration data
Service mode
The service mode functions similarly to the monitor mode. In addition, however, the
image captured by the sensor is shown.
Info
In the service mode the evaluation rate is therefore even slower than in the monitor mode.
Via the Service Report
data file, the reference image, the contour bands, the current image and, if any, the
image of the last FAIL evaluation are stored on the PC in the report file cs_report.html.
You can select and open the service report e.g. via the
item in the File
report is saved via the
the folder you indicated during program installation.
You have further possibilities in the service mode:
• If the result of the evaluation is FAIL the corresponding image is saved and you can
store this failed image for diagnostic or documentation purposes on your PC via
the Save failure image [bitmap]
• The image captured last can be stored on the PC via the
ton.
• You can reset the counters for the total number of evaluations and the number of
PASS and FAIL evaluations via the
36
All manuals and user guides at all-guides.com
button all relevant information of the active configuration
menu. You can enquire about the folder into which the service
Show resource paths....
button.
Service Mode button.
dialogue page via the
menu item in the
Reset statistics button.
Parameter
Open service report....
Help menu. This is
Save image [bitmap]
button.
menu
but-