Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Parameterisation connection
Connect the USB adapter cable E2D100 to the parameterisation connection of the
sensor. Ensure for connection of the M8 connector that the coupling nut is tightly
screwed into the internal thread of the sensor socket.
Only connect the USB connector of the adapter cable E2D100 with your PC
after installation of the software!
LED display
LED no. Colour
Type of indication Function
1
LED green
permanently lit
2
LED yellow
permanently lit
3
LED yellow
permanently lit
4
LED red
permanently lit
Software installation
Insert the CD with the dualis control panel operating program (E2D102) into your CD
drive. If the installation does not start automatically, use the following commands to
start it manually:
• Select the
Run...
• Activate the
Browse...
in the selection window.
• Open the setup.exe file and confirm the selection by
Follow the instructions of the installation program.
After successful installation connect the USB connector of the adapter cable E2D100
to your PC. This will start automatic hardware recognition of your operating system.
Follow the instructions of the hardware wizard and during the query for the process
for the driver selection select the option
All manuals and user guides at all-guides.com
flashing
operating voltage applied - sensor parameters not yet set;
data set has been loaded - sensor's parameters set and ready
communication with the PC is active (USB connection exists
connect sensor
contour has been detected - switching output switched
error message: contour has not been detected
output has not been switched
command in the start menu. A dialogue window will open.
button and change to the English directory on the CD ROM
menu item executed)
.
OK
The installation will start.
Browse searching for the driver of the unit.
.
23
Werbung
Kapitel
Inhaltsverzeichnis
