Establishing The Position Of The Locator; Adjusting The Crimping Depth - HARTING 09 99 000 0888 Bedienungsanleitung

Four-indent crimp tool 09 99 000 0888
Figure 4: Rotary positioner
Ⓐ
Figure 5: Rotary positioner
Figure 6: Setting the
crimping depth
16

Establishing the position of the locator

Select the series type that you will be processing:
Han D , Han E , Han
® ®
locator out of the latch and turn it until the requi-
red marking is lined up with the contact position.
The arrow Ⓐ will indicate the selected marking. The
locator will latch back into position when you release it.

Adjusting the crimping depth

In order to ensure the best error-free crimp connection, the
crimping depth (the gap between the crimping dies) must
properly correspond to the type of contact and wire diame-
ter in use. The proper setting must be used. These settings
can be found on the locator (refer to figure 6) or in table 2
on page 17. For example, the Han-Yellock
ponds to a diameter of 1.30 mm.
C or Han-Yellock
®
1.5 mm² corres-
®
HARTING Electric GmbH & Co. KG
. Pull the
®