Cabled Master/Slave Operation; Remote Control Ir-7 - Eurolite Multiflood Pro Ip Rgbw Wash Mk2 Bedienungsanleitung

Cabled master/slave operation

Several devices may be interconnected (max. 32) via DMX cables. Then all slave units can be synchronized
and controlled with the master unit without the need for a DMX controller. The devices must be set to the
corresponding operating modes.
1 Configure all slave units before connecting the master unit: Press the MENU button so many times until
SLAVE is indicated on the display. Confirm with the ENTER button.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Set the master unit to a stand-alone mode (STATIC, AUTO, COLOR, etc.). The interconnected devices
will now operate in sync.

Remote control IR-7

The device must be activated for remote control. For this, set menu item INFRARED to ON. When actuating
a button, always direct the remote control towards the sensor. There must be no obstacles between remote
control and the sensor. In DMX and slave mode, the remote control functions are deactivated.
Notes:
• The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
• If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
• Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.
Button Function
BLACKOUT LEDs off
Automatic mode
AUTO
program selection with (+)/(‒)
Strobe effect for automatic mode
STROBE
flash rate setting with (+)/(‒)
Running speed in
SPEED
setting with (+)/(‒)
Microphone sensitivity
SENSITIVITY
setting with (+)/(‒)
DMX DMX mode on/off
Color mode
MANUAL
select colors with R/G/B/W
Color fade mode
FADE
speed setting with (+)/(‒)
Total brightness
1-9
(1 = dark, 9 = bright)
33/44
automatic mode
00133982, Version 1.0