Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device may be fastened to a truss or similar rigging structure. The device must never be fixed swinging
freely in the room.
1
The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2
Block access below the work area and work from a stable platform when installing the device.
3
Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a list of suitable rigging hardware.
1
2
3
Screw one coupler via an M10 screw and self-locking nut onto the Omega holder. Insert the quick-lock
fasteners of the Omega holder into the respective holes on the mounting plate. Tighten the quick-lock
fasteners fully clockwise.
4
Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. Two
appropriate eyelets are installed on the device for fixation of the safety bond. Fasten the safety rope in
such a way that, in the event of a fall, the maximum drop distance of the device will not exceed 20 cm.
5
To align the LED unit, release the side-mounted thumb screws at the base, adjust the desired inclination
angle and retighten the screws.
6
After installation, the device requires inspections periodically to prevent the possibility of rot, deformation
and looseness.
(1) Coupler
(2) Quick-lock fastener
(3) Omega holder
28/44
00133982, Version 1.0
Werbung
Inhaltsverzeichnis
