Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
POWER SUPPLY
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts. The
power connectors are designed according to protection class IP65. Matching connection cables with special
plugs are optionally available. When not in use, make absolutely sure to close the connections with the
rubber sealing caps to prevent moisture and dirt from penetrating.
1
Connect the device via the mains cable to a grounded mains socket. Thus the unit is switched on.
2
To switch off the unit, disconnect the power plug.
3
Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.
4
The jack POWER OUT allows for power supply of further devices. To interconnect several devices,
connect the jack POWER OUT to the input POWER IN of the next unit until all units are connected. In
this manner, up to 8 devices can be linked at 230/240 input voltage and up to 4 devices at 110/115 input
voltage.
OPERATION
After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. If the DMX operating mode is set without a DMX signal being present, the display shows "NO
SIGNAL". The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board and controlled via remote control (EUROLITE IR-7), DMX signal and W-DMX
signal.
Operating buttons
Button
MENU
ENTER
UP
DOWN
Key lock
You can lock the operating buttons to e.g. prevent menu tampering. If the menu option PASSCODE is
enabled, the buttons will be automatically locked from the last command. In order to disable the key lock
function, press these buttons in the following order: UP, DOWN, UP, DOWN, ENTER.
Function
Selects the operating mode or returns to the initial screen.
Activates a value to be modified or saves a value when modifying.
Selects the next menu item or increases values when modifying.
Selects the previous menu item or decreases values when modifying.
30/44
00133982, Version 1.0
Werbung
Inhaltsverzeichnis
