Troubleshooting - EINHELL GE-CM 36/43 Li M Originalbetriebsanleitung

11. Troubleshooting

Fault
The motor fails to
start
The motor perfor-
mance drops
Cutting is irregular
Motor stops sud-
denly
Anl_GE_CM_36_43_Li_M_2x4Ah_SPK13.indb 28 Anl_GE_CM_36_43_Li_M_2x4Ah_SPK13.indb 28
GB
Possible causes
a) The connectors have become se-
parated from the motor
b) The mower is standing in high
grass
c) The mower housing is clogged
d) Safety switch is not inserted
e) Battery is not correctly inserted
a) The grass is too high or too damp
b) The mower housing is clogged
c) The blade is severely worn
d) Battery performance decrea-
sing
a) The blade is worn
b) Wrong cutting height
a) Battery is overloaded
b) Battery is empty
- 28 -
Remedies
a) Have repaired by the Customer
Service Center
b) Start in low grass or on an area that
has already been mowed; change
the cutting height if necessary
c) Clean the housing so that the blade
moves freely
d) Insert safety switch (see 6.)
e) Remove the battery and reinsert
(see 5.)
a) Correct the cutting height, change
the electronics setting
b) Clean the housing
c) Replace the blade
d) Check the battery performance
and charge the battery if necessary
(see 5.)
a) Replace or resharpen the blade
b) Correct the cutting height
a) Switch the equipment off and on
again. If this happens often, use a
battery with higher capacity (Ah)
b) Use a charged battery
15.07.2021 10:10:52 15.07.2021 10:10:52