Operation- / Work Instructions; Electrical Connection - Scheppach AB1900 Original Bedienungsanleitung

Switching ON / OFF (fig. 4)
Switching ON: Press the operating switch (2).
Switching OFF: Release the operating switch (2).
Continuous operation: Press operating switch (2) and lock with locking switch (10).
Stop continuous operation: Press and release operating switch.

10. Operation- / work instructions

Caution! For your safety, the machine must be held only at the two handles (3 and
5, fig. 1)!
This will avoid the danger of an electric shock through contact of lines during chiselling.
Always keep the chiselling tools sharp.
Note:
• Work only at low pressure when chiselling.
• Excessive pressure loads the motor unnecessarily.
• Sharpen the chisels in time and replace, if necessary.
Dust/Chip Extraction
Dusts from materials such as lead-containing coatings, some wood types, minerals and
metal can be harmful to one's health. Touching or breathing-in the dusts can cause allergic
reactions and/or lead to respiratory infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are considered as carcinogenic, especially in
connection with wood-treatment additives (chromate, wood preservative). Materials con-
taining asbestos may only be worked by specialists.
• Provide for good ventilation of the working place.
• It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for the materials to be worked.

11. Electrical connection

The electrical motor installed is connected and ready for operation. The connec-
tion complies with the applicable VDE and DIN provisions. The customer's mains
connection as well as the extension cable used must also comply with these regu-
lations.
Faulty power supply cables
Insulation damage often occurs at power supply cables.
34 | GB
www.scheppach.com