Safety Instructions - Logotherm LogoCool S-Line Technische Information Für Montage Und Betrieb

Please follow these safety instructions faithfully to eliminate hazards, personal injury and material damage.

1. Safety instructions

Target group
These instructions are intended exclusively for authorised trained experts.
Only trained experts or installers authorised by the respective competent utility company are permitted to work on
the heating system, the domestic water, gas and electric circuits.
Regulations
When carrying out work, you must comply with:
• The statutory accident prevention regulations,
• The statutory environmental protection regulations,
• The German Employer's Liability Insurance Association regulations,
• The pertinent safety requirements of DIN, EN, DVGW, TRGI, TRF and VDE,
• ÖNORM, EN, ÖVGW-TR Gas, ÖVGW-TRF and ÖVE,
• SEV, SUVA, SVGW, SVTI, SWKI and VKF,
• and all new and regionally applicable regulations and standards.
Instructions for working on the system and system parameters
• Disconnect the system from the mains and monitor it to ensure that no voltage is being supplied (e.g. at the
separate cut-out or a main switch).
• Secure the system against being restarted.
The cooling unit may only be installed in:
• Dry and not potentially explosive environments
• Enclosed rooms with temperatures of 5-50°C (not condensing)
• The devices must be installed in enclosed, frost-free spaces
• Observe the safety areas in accordance with 60529 when designing and installing the system
• Device protection code in accordance with EN 60520 IP42
Note:
The device is installed inside a building in an upright position on the wall, in a convenient location with sufficient
frost protection.
Potential equalisation or protective earthing in accordance with VDE:
The heating interface unit must be protected by potential equalisation or protec-
tive earthing according to the applicable regulations!
GB
3
GB