The Vpap Iii St-A System; Masks - ResMed VPAP III ST-A Bedienungsanleitung

The VPAP III ST-A System

Please refer to the illustrations in section A of the illustration sheet.
Please identify and familiarize yourself with the following components of the
VPAP III ST-A:
VPAP III ST-A front view (A-1)
•
VPAP III ST-A rear view (A-2)
•
Power cord (A-3)
•
Carry bag (A-4)
•
2 m air tubing (A-5).
•
WARNING
!
Do not connect any device to the auxiliary port. Although your health
•
care provider may connect specially designed devices to the auxiliary
port of the VPAP III ST-A, connection of other devices could result in
injury, or damage to the unit.
In the home environment, the only device that may be connected to the
•
communications port is a modem that is locally approved. Locally
approved modems may also be connected in the clinical environment.
In the clinical environment any PC that is used with the VPAP III ST-A
•
system must be at least 1.5 m away from, or at least 2.5 m above the
patient. It must also comply with IEC 60950 or equivalent.

Masks

You will also need a ResMed mask system (supplied separately).
The following ResMed mask systems are recommended for use with the
VPAP III ST-A:
Nasal Masks
Ultra Mirage™ Nasal Mask
•
Mirage™ Nasal Mask
•
Mirage Activa™ Nasal Mask
•
Mirage Vista™ Nasal Mask
•
Modular Nasal Mask.
•
Nasal Pillows Systems
Mirage Swift™ Nasal Pillows System.
•
Full Face Masks
Mirage™ Full Face Mask
•
Mirage™ Full Face Mask Series 2
•
Ultra Mirage™ Full Face Mask.
•
To select the appropriate setting for your mask, see "Settings for Mask Types"
on page 27.
The VPAP III ST-A System 9