Sleep Operation - Kaisai FLY KWX-09 Bedienungsanleitung

Setting Angle of Air Flow
•
Setting vertical angle of air ow
While the unit is on, use the SWING/DIRECT
button to set the direction (vertical angle) of
airflow.
1. Press the SWING/DIRECT button once to
activate the louver. Each time you press
the button, it will adjust the louver by 6°.
Press the button until the direction you
prefer is reached.
2. To make the louver swing up and down
continuously, press and hold the SWING/
DIRECT button for 3 seconds. Press it
again to stop the automatic function.
Setting horizontal angle of air ow
The horizontal angle of the air ow must be set
manually. Grip the de ector rod (See Fig.B)
and manually adjust it to your preferred direction.
For some units, the horizontal angle of the air ow
can be set by remote control. Please refer to the
Remote Control Manual.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set
louver at too vertical an angle for long periods
of time. This can cause water to condense on
the louver blade, which will drop on your floor
or furnishings. (See Fig.A)
When using COOL or HEAT mode, setting the
louver at too vertical an angle can reduce the
performance of the unit due to restricted air
flow.
Do not move louver by hand. This will cause the
louver to become out of sync. If this occurs, turn
o the unit and unplug it for a few seconds,
then restart the unit. This will reset the louver.
Caution: Do not keep louver at too
vertical an angle for long periods of
time. This can cause water condensation
to drip on your furnishings.
Fig. A
CAUTION
Do not put your ngers in or near the blower
and suction side of the unit. The high-speed
fan inside the unit may cause injury.
De ector rod
Fig. B
58
55

Sleep Operation

•
The SLEEP function is used to decrease energy The SLEEP function is used to decrease energy
use while you sleep (and don't need the same use while you sleep (and don't need the same
temperature settings to stay comfortable). This
temperature settings to stay comfortable). This
function can only be activated via remote control.
function can only be activated via remote control.
Press the SLEEP button when you are ready to
Press the SLEEP button when you are ready to
go to sleep. When in COOL mode, the unit will
go to sleep. When in COOL mode, the unit will
increase the temperature by 1°C (2°F) after 1
increase the temperature by 1°C (2°F) after 1
hour, and will increase an additional 1°C (2°F)
hour, and will increase an additional 1°C (2°F) after another hour. When in HEAT mode, the unit
will decrease the temperature by 1°C (2°F) after
after another hour. When in HEAT mode, the unit
1 hour, and will decrease an additional 1°C (2°F)
will decrease the temperature by 1°C (2°F) after
after another hour.
1 hour, and will decrease an additional 1°C (2°F)
after another hour.
The SLEEP function ends after 8 hours and then the
It will hold the new temperature for 5 hours, then
air conditioner will change to the normal operating
the unit will turn o automatically.
mode.
Note: The SLEEP function is not available in
FAN or DRY mode.
SLEEP Operation
+/- 1 C/2 F
Set
temperature
1hr
Saving energy during sleep
+/- 1 C/2 F
The device will
7 hours
keep running
until turned off
1hr timer o
by the user.
59
56