Kaisai FLY KWX-09 Bedienungsanleitung Seite 32

CAUTION
Before changing the lter or cleaning,
•
turn o the unit and disconnect its power
supply.
When removing lter, do not touch metal
•
parts in the unit. The sharp metal edges can
cut you.
Do not use water to clean the inside of the
•
indoor unit. This can destroy insulation and
cause electrical shock.
Do not expose lter to direct sunlight when
•
drying. This can shrink the lter.
Air Filter Reminders (Optional)
Air Filter Cleaning Reminder
After 240 hours of use, the display window on
the indoor unit will ash "CL." This is a reminder
to clean your lter. After 15 seconds, the unit will
revert to its previous display.
To reset the reminder, press the LED button
on your remote control 4 times, or press the
MANUAL CONTROL button 3 times. If you don't
reset the reminder, the "CL" indicator will ash
again when you restart the unit.
Air Filter Replacement Reminder
After 2,880 hours of use, the display window on
the indoor unit will ash "nF." This is a reminder
to replace your lter. After 15 seconds, the unit
will revert to its previous display.
To reset the reminder, press the LED button
on your remote control 4 times, or press the
MANUAL CONTROL button 3 times. If you don't
reset the reminder, the "nF" indicator will ash
again when you restart the unit.
CAUTION
Any maintenance and cleaning of outdoor
•
unit should be performed by an authorized
dealer or licensed service provider.
Any unit repairs should be performed
•
by authorized dealer or licensed servic
e
provider.
Maintenance –
Long Periods of Non-Use
If you plan not to use your air conditioner for an
extended period of time, do the following:
Turn on FAN function until
Clean all lters
unit dries out completely
Turn o the unit and Remove batteries
disconnect the power from remote control
Maintenance –
Pre-Season Inspection
After long periods of non-use, or before periods
of frequent use, do the following:
Check for damaged wires Clean all lters
Check for leaks Replace batteries
Make sure nothing is blocking all air inlets and outlets
62
59
Troubleshooting
SAFETY PRECAUTIONS
If ANY of the following conditions occurs, turn o your unit immediately!
• The power cord is damaged or abnormally warm
• You smell a burning odor
• The unit emits loud or abnormal sounds
A power fuse blows or the circuit breaker frequently trips
•
Water or other objects fall into or out of the unit
•
DO NOT ATTEMPT TO FIX THESE YOURSELF! CONTACT AUTHORIZED SERVICE PROVIDER
IMMEDIATELY!
Common Issues
The following problems are not a malfunction and in most situations will not require repairs.
Issue Possible Causes
Unit does not turn The Unit has a 3-minute protection feature that prevents the
on when pressing unit from overloading. The unit cannot be restarted within
ON/OFF button three minutes of being turned o .
The unit may change its setting to prevent frost from forming
on the unit. Once the temperature increases, the unit will start
The unit changes
operating in the previously selected mode again.
from COOL/HEAT
mode to FAN
mode The set temperature has been reached, at which point the
unit turns o the compressor. The unit will continue operating
when the temperature fluctuates again.
The indoor unit In humid regions, a large temperature di erence between the
emits white mist room's air and the conditioned air can cause white mist.
Both the indoor When the unit restarts in HEAT mode after defrosting, white
and outdoor units mist may be emitted due to moisture generated from the
emit white mist defrosting process.
4
63
60