Pin Assignment - Cameo CLPFLATPRO7G2 Bedienungsanleitung

SERIAL CONNECTION OF MULTIPLE LIGHTS
1. Connect the male XLR connector (3-pin or 5-pin) of the DMX cable to the DMX output (female
XLR socket) of the first DMX device
(e.g. DMX-Controller).
2. Connect the female 3-pin XLR connector of the DMX cable connected to the first projector to
the DMX input (male 3-pin socket) of
the next DMX device. In the same way, connect the DMX output of this device to the DMX input
of the next device and repeat until all
devices have been connected. Please note that as a rule, DMX devices are connected in series
and connections cannot be shared without active splitters. The maximum number of DMX
devices in a DMX chain should not exceed 32 units.
The Adam Hall 3 STAR, 4 STAR, and 5 STAR product ranges include an extensive selection of
suitable cables.
DMX CABLES
When fabricating your own cables, always observe the illustrations on this page. Never connect
the shielding of the cable to the ground contact of the plug, and always make certain that the
shielding does not come into contact with the housing of the XLR plug. If the shielding is connect-
ed to the ground, this can lead to short-circuiting and system malfunctions.

PIN ASSIGNMENT

DMX cable with 3-pin XLR connectors:
(pin 4 and 5 are not used):
Shield
1
3
2
DMX TERMINATORS (TERMINATING RESISTORS)
To prevent system errors, the last device in a DMX chain needs to be equipped with a terminating
resistor (120 ohm, 1/4 Watt).
3-pin XLR connector with a terminating resistor: K3DMXT3
5-pin XLR connector with a terminating resistor: K3DMXT5
PIN ASSIGNMENT
3-pin XLR connector:
1
3
2
1
3
2
DMX cable with 5-pin XLR connectors
5
5
4
4
3 3
2
2
1
1
Shield
5-pin XLR connector:
5
4
3
2
1
27