Cameo CLPFLATPRO7G2 Bedienungsanleitung Seite 16

This will take you to the submenu for setting the submenu items (see table, select with UP and
DOWN, confirm with ENTER, change value or status with UP and DOWN, confirm with ENTER).
The settings for each programme are made separately and are retained even after restarting the
device.
AUTO STANDALONE MODE
Dimmer Sets brightness
Speed Sets running speed
Delay Delay time for slave groups
STATIC STANDALONE MODE
The Static standalone mode allows the Dimmer, Strobe, R, G, B, W and A values to be set directly
on the device with values in a similar way to with a DMX controller. In this way, an individual
scene can be created without an additional DMX controller.
Starting from the main display, press MENU to enter the main menu. Using UP and DOWN, select
the Standalone menu item and confirm with ENTER. Again use UP and DOWN to select the
Static standalone mode and confirm with ENTER. Using UP and DOWN, now select the menu item
that you wish to edit and confirm with ENTER. You can use UP and DOWN to configure the desired
value between 000 and 255. The strobe effect values correspond to those in channel 2 of the DMX
table 3 CH Mode 1. Confirm all entries with ENTER.
CCT STANDALONE MODE (CORRELATED COLOR TEMPERATURE)
The CCT standalone mode allows the color temperature to be adjusted from 1800 K to 7500 K in
100 K steps, and the tint and brightness (dimmer) can also be adjusted.
Starting from the main display, press MENU to enter the main menu. Using UP and DOWN, select
the Standalone menu item and confirm with ENTER. Using UP and DOWN, select the standalone
mode CCT and confirm with ENTER. Now select the menu item you wish to edit using UP and
DOWN, confirm with ENTER and adjust the desired value using UP and DOWN. Confirm all entries
with ENTER.
16
0–100
0–100
0.0 s to 2.0 s