STEPCRAFT DL445 Betriebsanleitung Seite 62

9. Set the integrated zero point sensor to the middle position
to activate the positioning beam. The laser head should
be around 20 mm above the workpiece to allow for a
good focus of the laser. The positioning laser is a class 2
laser, comparable to a laser pointer.
10. Now move to the desired X- /Y-position using the positioning beam as
target marker. Set your workpiece zero points for X and Y.
11. Activate the integrated zero point sensor
(bottom position).
12. a) Start a tool length measurement in
WinPC-NC by navigating the menu
like this:
• Open Jog menu
• Move to...
• Block - zero point Z
60