Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Navigate to Basic Settings - Equipment. Activate Laser,
Length measurement and compensation and additionally
2
Surface block. Click
.
1
Continue to Basic Settings - Sensor. Enter 1 mm as Surface
block value. This setting will prevent the laser colliding with
the machine table. This value will possibly have to be adjust-
ed slightly later on. Click
and
.
Enable the integrated zero point sensor of the laser tool (bot-
tom position). Open the Jog menu in WinPC-NC. Click
or
press the F5 key on your keyboard.
Click Move to - Block - zero point Z. The Z-axis will descend
until the zero point sensor of the laser tool is triggered.
55
Werbung
Kapitel
Inhaltsverzeichnis
