Warranty & Safety; Chimney Fire - TermaTech TT23RG Montage- Und Bedienungsanleitung

mechanism/handle and magnets.
The warranty does not cover faults which are due to:
• If the user/mounting guide is not being followed
• The mounting has been carried out incorrectly
• Overheating / deterioration of materials, caused by the use of incorrect type of fuel, petro-
leum coke or too much fuel
• that the product has been connected to a chimney with poor drawing qualities. For example
chimneys that are too short or are leaking.
• The product being positioned or has been positioned/kept in unheated or damp surroundings.
• The product being in bad repair or not maintained according to the instructions.
• Normal wear and tear of wearing parts/expendable parts as well as the varnish.
• Similar circumstances which are not due to material or manufacturing faults.
The lesser defects below, which cannot support any claim, can occur in the product:
• Naturally occurring variations in the colour nuances and marbling on the soapstone, sandsto-
ne and other stone cladding.
• Sounds which occur during burning are normal. This occurs when the metal expands and
retracts.
If a fault occurs during delivery to the customer or if such fault arises during the warranty period
which is covered by this warranty, TermaTech A/S agree to send a suitable replacement part free
of charge to rectify the fault. Any additional obligation of TermaTech A/S to remedy the fault, for
example in the form of installation of the replacement part does not exist.
In addition the purchaser has, apart from the right to a replacement part, no right to either
direct or indirect damages.
Repairs of faults or replacements of parts on the product does not extend the product or replace-
ment parts warranty period. Neither does a new warranty period begin for the product or for the
replaced part.
Apart from the above warranty rules, the consumer also has those rights which are evident from
the obligatory consumer regulation.
Review
Any fault or defect must be examined by the dealer who has sold the product.
The purchaser must be able to prove that the product was purchased via the dealer and when it
was bought, in the form of an invoice/receipt. The purchaser must specify the model and produc-
tion number which is stated on the product. If the purchaser wishes to refer to a fault, the dealer
must be informed within 14 days of the fault being detected.
Warranty & Safety
Any unauthorized changes to the wood-burning stove will be viewed as structural change and
thereby the warranty will be void. Safety is also jeopardized.
HINTS
Lighting after long break
If the stove has not been used for a long time the chimney should be checked for possible block-
age before lighting. Furthermore it is a good idea to remove any dust from the wood-burning
stove as it might smell after a long break.

Chimney fire

In case of chimney fire the doors, drawers and damper of the wood-burning stove must be closed
immediately in order to shut of the supply of oxygen. The relevant authorities must be notified if
necessary. The stove must not be used until the chimney has been inspected.
Kindling is the designation for finely split wood/sticks that are about 20-30cm long and have a
diameter of 2-5cm.
Note:Dont use alcohol, petrol, or other flammable liquids when you ignite the stove.
Wood like birch, beech, oak, ash, elm, pine wood and wood from fruit trees is all suitable for
splitting into firewood.
Waste products like pressure-treated wood, chipboard, coloured brochure or glossy paper must
not be used in a wood-burning stove. They develop hydrochloric acid or heavy metals which
cause a lot of damage to the stove and the environment.
Firewood should have a diameter of 7-9 cm and be no more than about 30 cm long, otherwise
it will get too close to the side of the stove (at the CE-testing firewood at a length of 22 cm was
28