Year Warranty - TermaTech TT23RG Montage- Und Bedienungsanleitung

4. Put 2-3 pieces of firewood in the stove (length about 22cm), about 1,5 kg total. The pieces
are put in the bottom of the stove and parallel to the front of the stove with equal distance to the
stove's sides and with mutual distance of about 1 cm. The front piece is best lit if it has a split
side that is turned to the door and one in the embers. Close the door completely immediately.
Make sure you don't overfill the chamber, max. 17 cm from the bottom plate of the combustion
chamber.
5. The damper is opened so it is about 2/3 open to fully open (between the left and middle
position) and after about 5-10 minutes the damper can be set to about 1/3 open. How much the
damper should be open depends on the individual chimney's draught, but the flames should now
stabilise to a calm fire. It is important that the fire gets enough air to secure clean and efficient
heating.
6. When the wood has burned to embers (after about 45-60) you start again from point 3.
MAINTENANCE – always use original parts
Maintenance and cleaning of the stove should only be performed when the stove is cold.
The daily maintenance is limited, but once a year the stove should get thorough maintenance.
The combustion chamber should be cleaned for ashes and soot and the door hinges and the clo-
sing mechanism should be lubricated.
The surface is maintained by brushing it with a soft, long-haired brush or by using the vacuum
cleaner with a brush. The stove can also be dusted with a duster. Always remember: only when
the stove is cold. Do not use water or chemicals.
Joints/gaskets can look okay, but they collapse under the heat and thereby lose the ability to
keep the stove sealed. Jointings should be changed as needed as it is important to good combu-
stion and a clean window that the stove is sealed.
The insulation plates in the combustion chamber that are broken or worn can easily be changed
as they are loosely fixed. The material used is called Vermiculite and is a porous, but very suitable
insulation material. It has no effect on the stove's efficiency that the insulation cracks. However, it
should be changed when the wear surpasses half of the original thickness.
Painting the stove with Senotherm-spray can cover spots or small scratches from kettles and
such. Larger damages needs to be ground with fine steel wool, vacuumed and then sprayed.
The can has to be shaken vigorously and then sprayed on at a distance of 15-20 cm. It is very
important that the stove is not in use and completely cold before you use the spray due to the fire
hazard. In order to keep the stove's varnished surfaces looking nice for years to come you should
try to avoid touching the varnished surfaces when the stove is hot. Make sure to have sufficient
ventilation when using spray paint.
Glass normally does not need any maintenance apart from cleaning. This is most easily done
by using TermaTech's glass cleaner. Remember only to use glass cleaner when the stove is cold.
Glass is made of ceramic glass, be sure of environmentally disposal.
Original parts which need to be changed due to wear can be found at your dealer. Because of fit
etc. only original parts from TermaTech should be used.
Right to claim compensation for defective product is under current law. When stating
deviations the use of the product must be suspended immediately and the dealer must be con-
tacted.
Chimney/Flues Must be swept on regular occasions, as per manufacturers recommendations.
5 YEAR WARRANTY* / RIGHT TO INVOKE LACK OF CONFORMITY

5 Year warranty

If defects/faults are ascertained, use of the wood burner must be stopped immediately and the
dealer contacted.
Provided normal operation of the wood burner, TermaTech offers a 5 year warranty on material
and manufacturing faults on the load-bearing frame, exclusive of the combustion chamber.
Combustion chamber The following is not covered by the warranty
Combustion chamber, cast iron parts (bottom, door, grate) insulation material (vermiculite plates)
smoke deflector plates, glass, gaskets, the closing mechanism/handle and the handle.
Exterior parts The following is not covered by the warranty
Varnished plates/surfaces, stone facings, glazed tiles, concrete and glass, as well as the closing
27