Electrolux EH7K1SW Benutzerinformation Seite 23

CAUTION!
Carefully handle the glass,
especially around the edges of
the front panel. The glass can
break.
Step 1 Fully open the door.
Step 2 Lift and press the clamping levers
(A) on the two door hinges.
Step 3 Close the oven door to the first
opening position (approximately 45°
angle). Hold the door with one hand
on each side and pull it away from
the oven at an upwards angle. Put
the door with the outer side down
on a soft cloth on a stable surface.
Step 4 Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
Step 5 Pull the door trim to the front to re‐
move it.
Step 6 Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
Step 7 Clean the glass panel with water
and soap. Dry the glass panel care‐
fully. Do not clean the glass panels
in the dishwasher.
Step 8 After cleaning, do the above steps
in the opposite sequence.
Step 9 Install the smaller panel first, then the larger and the door.
Make sure that the glasses are inserted in the correct position otherwise the surface of the door
may overheat.
A
45°
2
B
A
1
ENGLISH 23