Power Cable Connection - Pioneer anh-p10mp Installationsanleitung

Connecting the Units

Power cable connection

Note
Depending on the kind of vehicle, the function of
3* and 5* may be different. In this case, be sure
to connect 2* to 5* and 4* to 3*.
1*
3*
5*
C a p ( 1 * )
When not using this terminal,
do not remove the cap.
Yellow (3*)
Back-up (or accessory)
Red (5*)
Accessory (or back-up)
Speaker leads
: Front left +
White
: Front left ≠
White/black
: Front right +
Gray
: Front right ≠
Gray/black
Note
When a subwoofer is connected to this unit
instead of a rear speaker, change the rear
output setting in the Initial Setting. (Refer
to the Operation Manual.)
The subwoofer output of this unit is
monaural.
9
En
2*
4*
Yellow (2*)
To terminal always supplied with power
regardless of ignition switch position.
Red (4*)
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Green
Green/black
Violet
Violet/black
ISO connector
Note
In some vehicles, the ISO connector
may be divided into two. In this case,
be sure to connect to both connectors.
This Product
Connect leads of the same
colour to each other.
Fuse holder
: Rear left + or Subwoofer +
: Rear left ≠ or Subwoofer ≠
: Rear right + or Subwoofer +
: Rear right ≠ or Subwoofer ≠
Aerial jack
Fuse resistor
Fuse resistor