Connecting The System - Pioneer anh-p10mp Installationsanleitung

Connecting the Units

Connecting the System

GPS aerial jack
Note
The position of the handbrake switch
depends on the vehicle model. For
details, consult the vehicle owner's
manual or dealer.
LIGHT GREEN LEAD AT POWER CONNECTOR IS
DESIGNED TO DETECT PARKED STATUS AND
MUST BE CONNECTED TO THE POWER
SUPPLY SIDE OF THE HANDBRAKE SWITCH.
IMPROPER CONNECTION OR USE OF THIS
LEAD MAY VIOLATE APPLICABLE LAW AND
MAY RESULT IN SERIOUS INJURY OR DAMAGE.
Connection method
Clamp the handbrake switch
pwoer supply side lead.
Clamp firmly with needle-
nosed pliers.
5m
2m10cm
This product
TEL terminal
20cm
Refer to a Handsfree Telephone Unit's
manual. (sold separately)
WIRED REMOTE INPUT
20cm
Refer to Wired Remote Control's manual.
(sold separately)
Light green
Used to detect the ON/OFF status of the handbrake.
This lead must be connected to the power supply side
of the handbrake switch. If this connection is made
incorrectly or omitted, certain functions of your
navigation system will be unusable.
Power supply side
Earth side
Handbrake switch
GPS aerial
8
En