To Guard Against Electromagnetic Interference; Before Installing; Installation Notes - Pioneer anh-p10mp Installationsanleitung

Installation
To guard against electromagnetic
interference
• In order to prevent interference, set the fol-
lowing items as far as possible from the main
unit of this Navigation System, other cables
or leads:
– TV aerial and aerial lead
– FM, MW/LW aerial and its lead
– GPS aerial and its lead
In addition you should lay or route each aerial
lead as far as possible from other aerial leads.
Do not bind them together, lay or route them
together, or cross them.
Such electromagnetic noise will increase the
potential for errors in the location display.

Before installing

• Consult with your nearest dealer if installation
requires the drilling of holes or other modifi-
cations of the vehicle.
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all con-
nected up properly, and the unit and the sys-
tem work properly.

Installation notes

• Do not install this unit in places where it may
become subject to high temperatures or
humidity, such as:
* Places close to a heater, vent or air condi-
tioner.
* Places exposed to direct sunlight, such as
on top of the dashboard or the rear shelf.
* Places that may be splashed by rain, for
example close to the door.
• When installing the unit choose a position
that is strong enough to bear the weight of
the unit. Choose a position where this unit
can be firmly installed, and install it securely.
Unless this unit are securely attached, the
current location of the vehicle cannot be dis-
played correctly.
• Check that a disc can be ejected with this unit
installed.
15
En
• Install this unit horizontally on a surface
within +30 degrees to 0 degrees tolerance
(within five degrees to the left or right of your
vehicle's direction of travel). Mis-installing the
unit with the surface tilted more than these
tolerances would increase the potential for
errors in the location display, and might oth-
erwise cause reduced display performance.
5°
• The cords must not cover up the area shown
in the figure below. This is necessary to allow
the amplifiers and navigation mechanism to
dissipate heat freely.
Do not close this area.
• The semiconductor laser will be damaged if it
overheats, so don't install the unit anywhere
hot — for instance, near a heater outlet.
30°