Demo Mode - Pioneer anh-p10mp Installationsanleitung

Setting the Navigation
8 Enter the required tyre size using the
rotary stick and confirm the entry by press-
ing for more than 2 seconds.
The left " " cannot be entered. 3 numbers must
R
be entered before and after the slashes. Insert a
" " before any missing numbers.
0
Example:
Specification in vehicle registration papers:
185/55R15 81T
Entry into unit:
185/055/015
Selected between
NEW TYRE TREAD
by turning the rotary stick to enter
TYRE TREAD
the approximate tread depth value. Press the
button to make a selection.
NAVI/OK
9 The previously entered data is displayed
once more. If the data entered is correct,
press the button.
NAVI/OK
If correction is necessary, select
turning the rotary stick and press to confirm.
The values can then be re-entered.
10 After confirming the tyre data or the pre-
viously confirmed point
, the next display appears.
BRATION
and
USED
by
MODIFY
START SELF-CALI-
11 After 8 seconds, the unit switches to the
main navigation menu or the calibration
journey is requested.
The unit is now in calibration status 2. Absolute
precision is, however, only achieved from cali-
bration status 3.

Demo mode

Demo mode is intended for demonstration pur-
poses.
1 In service garage mode, select DEMO
using the rotary stick and press to confirm.
Select between and
ON
the button. By holding down the rotary
NAVI/OK
stick, the setting is adopted.
You can now enter a destination as described in
the operation guide.
2 To switch off demo mode, select OFF
with the rotary stick and press to confirm.
by briefly pressing
OFF
En
28