Troubleshooting; Cleaning And Storage - Beurer IH 30 Gebrauchsanweisung

4. Inhale the medicament prescribed by your doctor. The Inhalator is designed so that the
inhalation rate increases after a few minutes. It begins at a
minimum.
5. When the mist is no longer constant, this indicates that the
medicament cup is empty. Inhale until no more mist is pro-
duced or the Inhalator switches off (the Inhalator switches off
automatically after 10 min. of use).
6. Switch off the Inhalator by pressing the ON/OFF button. The indicator lamp goes out. Unplug
the power plug of the power line adapter from the socket outlet and unplug the small plug
from the socket underneath the Inhalator.
7. Empty the medicament and water residues (WARNING: HOT!) and clean the Inhalator as de-
scribed under "Cleaning". Allow the Inhalator to cool down for 30 minutes before re-use.

Troubleshooting

If problems still occur despite the following checks, send the Inhalator for repair to the address
appropriate for you.
Problem
The Inhalator does not react when the ON/
OFF button is pressed
Low or no nebulization
The fan is not operating correctly

Cleaning and storage

Disconnect the power supply before cleaning. Do not immerse the Inhalator in water; it could
be irreparably damaged. On each occasion after use, we advise you to clean the Inhalator as
follows:
1. Remove the top cover, the medicament cup, air filter and filter case (pull down and out from
the rear protective sheath) and clean these parts with a damp cloth and a mild detergent or
disinfectant according to the manufacturer's instructions. Clean the extension tubing and
inhalation masks in the same manner.
2. Clean the case with a damp, soft cloth and exclusively with water. Rinse the water tank tho-
roughly with clear water.
3. Use only a soft, dry cloth to clean the small fan and the air inflow under the rear cover. Only
the cover can be sterilized with boiling water. The Inhalator, the power line adapter and the
rechargeable battery must not be exposed to direct sunlight, high temperatures or damp-
ness.
cause/solution
Check that the power line adapter/battery is
connected to the Inhalator correctly. Check
that the water tank has been properly filled.
Check that the battery is properly charged.
Make sure that the medicament cup is suf-
ficiently full (min. 2ml - max. 5ml) and is not
broken. Check that the Inhalator under the
medicament cup is clean.
Check that the fan is securely and correctly
connected to the motor shaft.
13
max. 5ml
max. 5ml
app. 4ml
ca. 4ml
at least 2ml