Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; Technical Specifications - Beurer EM 41 Gebrauchsanleitung

Rückengürtel
Vorschau ausblenden Andere Handbücher für EM 41:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Extending the belt
If the belt is not adequate for your waistline, you
can use the extension belt provided. Depending
on waste size, the connection panel with clip clo-
sures might not be positioned in the centre of the
body. It is important that the belt is positioned
correctly, therefore the electrodes C must be to
the left and right of the spinal column.
4. Connect the digital TENS/EMS
EM 41 device
Connect the connection cable with the clip closures on
the belt.
You can connect the white cable to channel CH1 and
the grey cable to channel CH2.
Guide the connection cable plugs into the sockets on
the front of the device.
Do not pull, twist or make any sharp kinks in the cables.
Do not switch on the digital TENS/EMS
EM 41 device until the belt is correctly positioned.
See 'positioning the belt'.
Programme suggestion EM 41
To use the back-ache belt, we recommend the TENS
programmes 2 /9 /10 on your TENS/EMS EM 41 de-
vice.
Cleaning the belt
When you have removed the connection cables from the
belt, you can clean the belt using a damp cloth. To do
so, use a mild soap solution or liquid detergent. Do not
use bleaching agents.

5. Troubleshooting

Problem/
Possible cause /remedy
question
You feel an
The electrodes are poorly moiste-
unpleasant
ned. This can lead to skin irritation,
sensation from
as the current is no longer distribut-
the electrodes.
ed evenly over the entire surface.
Switch off the unit. Remove the
belt, sufficiently moisten the elec-
trodes and your lower back again
and start the programme again
according to the instructions.
The skin in the
Discontinue the treatment imme-
treatment area
diately and wait until the skin con-
becomes red.
dition has normalised. Temporary
skin reddening under the electrode
is harmless and can be explained
by the localised increase in blood
flow.
However, if the skin irritation
persists and you feel itching or irri-
tation, consult your doctor before
continuing use.
The cause may be an allergy to the
surface of the electrode.

6. Technical specifications

Belt size for wa-
ist sizes from
approx. 75 to 140 cm
Electrode size
approx. 81 x 65 mm
Operating con-
0 °C to 40 °C, 20 to 65% relative
ditions
humidity
Storage
0 °C to 55 °C, 10 to 90% relative
humidity
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis