TermaTech BIO 70 Bedienungs-, Wartungs- Und Installationshandbuch Seite 8

If you experience Problems
Problem
There is smoke or a
strange odor that
comes from the
burner when being
in
function
The burner does
not ignite
The flame is not off
when closing the lid
Possible Cause
A.There might be other elements that are
burning in the burner.
B. Use of wrong fuel (it's imperative that you use
ONLY fuels with ethanol base).
C. Have placed something around or on top of the
flame that is not approved.
D. If the burner is empty (the flame is turned off)
or if you have just turned off the flame, this is
normal.
Exactly as when you turn off a candle.
E. The ethanol quality you 're using is not good
enough.
A. Not enough fuel in the burner.
B. You haven't used the proper fuel (it's obligatory
to use ONLY fuels with ethanol as main
substance).
C. Τhe opening of the burner does not have
sufficient air for the ignition of the flame.
D. The fuel is cold and it takes time to ignite.
E. If the burner is used outdoors (not suggested),
the fuels could have been mixed with rain water.
A. Maybe the speed used to close the lid of the
burner was very slow.
B. There are obstacles in the mechanism.
▪ Turn off the burner and wait until it
gets cold.
▪ Clean the burner and remove other
elements.
▪ Contact with the manufacturer
/supplier for proposals of
appropriate/suggested fuels.
▪ The level of the fuel, must be high.
▪ Check the type of the used fuels.
▪ Open the control door of the flame
completely and repeat the initial
procedure till the burner is getting hot
and finally ignites.
▪ If the burner if full of water empty the
content and refill with pure fuel.
▪ Make sure that no obstacles are in the
route of movement of the burner's
quenching shutter.
▪ Try again to turn off the flame with an
abrupt and quick move of the shutter.
▪ If you have no results let the fuel be
fully consumed and the flame will turn
off itself. Contact with the
manufacturer/supplier for assistance.
▪ Do not use the burner until it has been
maintained.
▪ If the burner is overflowed and the
flame is vivid prepare, in any case, the
fire-extinguisher and oversee
the flame until it returns in normal
levels, provided that you are not able
to turn it off.
▪ Do not blow and do not try to cover
the flame with blanket in order to turn
it off.
▪ Do not use water to turn it off.
5
Action