Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Photo.1
Photo.3
Photo.4
Photo.6
Photo.7
INSTRUCTIONS
Photo.2
Photo.5
To light up the burner use a lighter
with a long spout. Place the ledge
of the lighter in the hole of the
burner so it touches the ceramic
stone and then light (Photo 6).
Photo.8
7
On the surface of the burner there is a
special filling hole (Photo 1). Check that the
cover
opens
and
ATTENTION! At its initial position always
close the cover of the burner and open the
special filling hole (Photo 2).
To place the Burner in the special hole into
the built-in fireplace construction, use the
special handle for Burner's placement as
presented on the photo (Photo 3). Use the
same special handle also in case you need to
move/remove
the
Burner
position.
ATTENTION: Never fill the burner from its
main opening because there might be small
hearths , non visible. To fill the burner with
Bioethanol, always use the special tools to
control the level of the fuel (Photo 4). Thus,
avoid the case of fuel being spilled out and
around of the burner's hole, while you make
sure that ignition will be completely safe.
Place the filling funnel into the filling hole
and fill with attention using a vessel, (Photo
5). The filling is realized in 2 parts. During
the first filling, as soon as the fuel has
reached the Max. mark, stop for 10-15'',
letting it absorb a part of the fuel. By the
passage of the 10-15'', when the fuel level
has dropped a little, repeat the same
procedure till the fuel level reaches again the
Max. mark.
Now the burner is completely filled.
To shut off the burner, use the special tool
that
is
provided
with
Place the pin of the tool to the 2
special holes on the top of the burner's lid
(Photo 7) and draw it till its completely
closed position (Photo 8). Let the lid stay in
this position for about 5 minutes to make
sure that the flame of the burner has been
extinguished completely. In case that it has
not yet, move again the lid to its initial open
position and draw it again, with a more
abrupt and quick move, till its closed
position. Again let the lid stay in this
position for about 5 minutes.
closes
properly.
from
this
the
burner.
Werbung
Inhaltsverzeichnis
