Safety Instructions; Maintenance Instructions - TermaTech BIO 70 Bedienungs-, Wartungs- Und Installationshandbuch

▪ Adjust the flame's height, with the provided tool, to adjust the size of the burner opening.
▪ Avoid long periods of non-use of the burner while the fuel is volatile and will be vaporize. If you intend not to use it
for long period of time, empty the fuel.
ATTENTION! The burner must get cold to the environment's temperature before its reignited.
Do not ignite and do not fill the burner while being in warm condition.
Always check that the burner is completely off.
Quenching
▪ Do not turn off the burner using water, there is danger of a small flame burst.
▪ To turn off the burner use the provided tool (See Photo.5&6 - Page 7) with which you will move the shutter till its
closed position. Leave the shutter on this position for at least five (5), to make sure that the burner's flame is completely
off.
▪ Use only the provided tool to move the shutter since it is very warm and there is danger of burning in case of
barehanded contact.
▪ If the flame does not turn off completely when having moved the shutter to its closed position, move it back again to
its open position and try again to turn it off drawing the shutter with a faster and more abrupt move this time.
▪ There is the possibility after a long-term use the lid to be dilated as a result the shutter not to move normally. Careful
bump with the moving tool of the shutter. Be careful not to cause any damage to the burner.
▪ If after closing the burner there remains any fuel in the burner, keep the lid closed to prevent its vaporization. When you
want to use it again, fill the burner with fuel till MAX and then turn it on again.
Burning Time
▪The burner, depending on the model, has a certain fuel capacity (maximum capacity).
▪Among the technical characteristics of each model, there is the maximum burning time that refers to the burning of full
burner in a completely open position of the shutter (max. flame).
▪To save more fuel and extend burning time you can reduce the burning hole (lower flame) using the special tool.

Safety Instructions

The burner has on the surface of the filling opening a visible and permanent symbol to indicate that the filling is not allowed
when ignited or when the burner is in hot condition.

Maintenance Instructions

ATTENTION! The burner is getting hot when burning. After shutting it off, the burner remains warm. Leave it at least 30
minutes to reach the surrounding temperature, before you touch it barehanded.
Clean the surface of the burner only after the burner has cooled off.
ATTENTION! The cleaning and the maintenance of the device must not be performed by unsupervised children.
▪Do not use harsh cleaning or cleaning with any kind of powder because it can cause damage to the surface of the burner.
▪To avoid fuel leakage, make sure that it is empty of fuel before cleaning.
▪For the burner's cleaning use fresh cloth. Use only water and if needed soft cleaning liquid (like for dishes).
For tough stains or dull of the surface wipe with spirit.
▪Before using the burner again make sure that you have placed again properly all its parts.
▪Regular check for damages of all the obvious parts of the burner must be done. In case of damage replace the damaged
part.
▪If any problem happens during use, contact with the manufacturer or the supplier for assistance.
Photo 1: Signs of Burner Safety
4