Installation Procedure - Carrier 40VA003D7FAQEE Installations- Und Benutzerhandbuch

Installation procedure

1. Pre-installation
The installation location selected should meet the following conditions and be approved by users.
• The strength should be sufficient to withstand the weight of the connection kit
• There is no significant tilt on the plane.
• Ensure that there is enough space for installation and maintenance.
• Space should be available for inspection on the side and top of the electric box.
• The length of piping between the indoor and outdoor units shall be within the permissible range (referring to the
specification attached to the outdoor unit).
• The connection kit should be installed at locations places where noise will not influence the customers too much
(washroom, passageway, warehouse, equipment room, etc.). Avoid installation at locations that require silence
(bedroom, drawing room, meeting room, office).
Note:
• The electrical box can be changed as show in item 3 connection kit installation.
• Noise may be generated by the connection kit because of control during operation or stopping of an indoor unit. If it
is installed in the ceiling where it is exposed, adequate precautions need to be taken at the installation location.
<Notice item>
• Check whether the installation location can sufficiently withstand the weight of connection kit and set the hoisting
bolts by reinforcing the beam if necessary. Use hoisting bolts in installation (referring to 2 for the preparation before
installation).
• Install the power wiring and power line of the connection kit more than 1 m away from TVs and radios to prevent
image clutter and noise. However, noise may be generated even if the distance is more than 1 m depending on the
different waves.
Front view
Min200
Front view
Wall mounted (mm)
Celing mounted (mm)
Min200
8
Min200
Top view
Side view
Min200
Min50
Min300