Gemü Q50 eSyStep Betriebsanleitung Seite 81

11.4.21 Function digital output 2
The output function can be set with the Function digital output 2 parameter.
Index Sub- Off- Access
In- set Rights
dex
0x4D 0 0 R/W
Description of parameter values
Index name
Function
digital output
11.4.22 Logic digital inputs / outputs
The inputs and outputs can be inversed with the Logic digital inputs/outputs parameters.
Index Sub- Off- Access
In- set Rights
dex
0x4E 1 0 R/W
2 1 R/W
3 2 R/W
4 3 R/W
Description of parameter values
Index name
Logic digital inputs /
outputs
www.gemu-group.com
Length Index name
2 bits Function digital
output 2
Parameter
Length Index name
1 bit Logic digital
inputs / outputs
1 bit
1 bit
1 bit
Parameter
Input 1
Input 2
Input / output 1
Output 2
Parameter
Values
0 (Output Open) Signal is output with the corresponding valve
position. Detection of Open depends on the setting of the
parameter Position Feedback (index 0x51 (see "Actuator po-
sition feedback", page 84)) and a correct initialization.
1 (Output Close) Signal is output with the corresponding valve
position. Detection of Close depends on the setting of the
parameter Position Feedback (index 0x51 (see "Actuator po-
sition feedback", page 84)) and a correct initialization.
2 (Output Error) Only output error detection.
3 (Output Error & Warning) Output error and warnings.
Parameter
Input 1 Boolean
Input 2 Boolean
Input / output 1 Boolean
Output 2 Boolean
Values
0 (Active high) Input 1 not inversed.
1 (Active low) Input 1 inversed.
0 (Active high) Input 2 not inversed.
1 (Active low) Input 2 inversed.
0 (Active high) Input/output not inversed.
1 (Active low) Input/output inversed.
0 (Active high) Output not inversed.
1 (Active low) Output inversed.
81 / 100
11 Specific data IO-Link (pin 6)
Type Default
uint:8 2
Description
Type Default
0
0
0
0
Description
Values
0
1
2
3
Values
0
1
0
1
0
1
0
1
GEMÜ Q50 eSyStep