Troubleshooting - Clarion VT1010E Benutzerhandbuch

7. TROUBLESHOOTING

If operations freeze, the screen goes blank, or the player otherwise does not function
properly, try turning it off and back on again. If it still does not respond, press the reset
button on the front panel.
PLAYER DOES NOT TURN ON
 The car's ignition may be off. Turn on the ignition to the ACC (Accessory) position.
 The player may not be on. Turn the player's power on.
 There may be condensation in the player. Wait for about one hour or until the
condensation evaporates.
 A fuse may be blown. Check the fuses at the end of the monitor installation cables and
on the vehicle.
 The player may be disconnected. Check all connections. See the installation
instructions.
 The remote control battery may require changing.
 Dirt may be covering the remote's infrared lens. Clean the lens with a soft damp cloth.
PLAYER IS ON BUT WON'T PLAY THE DISC
 The disc may be inserted incorrectly. Reinsert the disc with the label side up (facing the
ceiling of the car).
 The disc format may not be supported.
 The disc may be dirty or scratched. Clean or replace the disc.
THE PLAYER SUDDENLY STOPS WORKING
 There is an error in the player. Turn the player off and on again. If it still doesn't
respond, press the RESET button.
THE PLAYER WORKS ERRATICALLY
 The remote control battery needs replacing.
 The IR window on the player or remote control is dirty. Clean the IR windows with a
soft damp cloth.
 The connections are loose. Check and tighten all connections.
THE PICTURE OCCASIONALLY SKIPS
 The disc is dirty or scratched. Clean or replace the disc.
VT1010E/VT1510E
Player with the monitor open
7. TROUBLESHOOTING
Reset button
29