Installation And Wiring; What Is Included In The Box; Before You Begin - Clarion VT1010E Benutzerhandbuch

5. INSTALLATION AND WIRING

5. INSTALLATION AND WIRING
Do not attempt to install or service your player yourself. Installation and servicing require
experience in electronic equipment and automotive accessories. If you do not have the
knowledge or experience this installation may be dangerous and could expose you to the
risk of electric shock or other hazards.
Read these instructions and precautions carefully. Improper installation can damage the
monitor and the vehicle.

WHAT IS INCLUDED IN THE BOX

In addition to this manual, the box contains:
 1 - Player
 1 - IR remote control with battery
 1 - Audio/video RCA cable with 3.5mm connector
 1 - Power harness
 1 - RCA output cable
 1 - RCA input cable
 6 - ST4.2 x 16, 4 - CM4 x10 screws (VT1010E)
 10 – ST4.2 x 16, 8 – CM4 x 8 screws (VT1510E)
 1 - Metal mounting plate
 1 - Rubber gasket
 2 - Headphones and 4 AAA batteries
Note:
Use only the contents of this package to install and use the system. Using accessories
not provided with this player may damage the player.

BEFORE YOU BEGIN

1. Verify that the vehicle electrical components function, including: power windows,
power door locks, air conditioning, lights, etc.
2. Identify the polarity of the dome light circuit and set the switch on the bottom of the
overhead monitor housing.
3. Test fit the location of the overhead monitor system to ensure it will not interfere with
the operation of the vehicle.
4. If applicable, verify that the monitor, when mounted, will not interfere with the operation
of the sun roof.
5. Carefully mark the location with masking tape.
6. Lower the vehicle's headliner down to see if a roof support beam is available to screw
the mounting bracket. If a support beam is not available, use a 3/4-inch piece of
plywood cut to the appropriate size. Attach the plywood to the roof of the vehicle using
silicone. Allow for adequate drying time.
7. Determine the location of any additional audio/video sources.
8. Disconnect the negative battery terminal before making any wiring connections.
22 VT1010E/VT1510E