Clarion VT1010E Benutzerhandbuch Seite 17

Headphone components
Power switch
Installing batteries in the headphones
If this is the first time you're using the system, install batteries in the headphones.
Change the batteries when you begin to hear distorted audio that cuts in and out.
1. Rotate the left earpiece so the battery cover is accessible.
2. Slide the battery cover down.
3. If replacing the batteries, remove the discharged batteries.
4. Insert the new AAA batteries according to the polarity
marked inside the battery compartment.
5. Slide the battery cover back into place.
Setting the volume
The volume control is on the headphones. Turn the volume dial up or down.
Note:
Some noise may be audible depending on the type of encoder software used while
recording. This noise is not caused by the VT1010E/VT1510E
Direct sunlight and temperature extremes
Do not leave the headphones in direct sunlight or extreme temperatures.
VT1010E/VT1510E
Headphones
4. OPERATIONS
Power light
Volume dial
Battery cover
Batteries installed
Close-up with batteries installed
15