Replacing The Cutting Blade - Parkside PAS D5 Bedienungs- Und Sicherheitshinweise

Replacing the cutting blade

(Fig . K)
m
CAUTION! When the saw blade
inserted to the blade guard, do not touch the sharp cutting edge .
To avoid injury, wearing suitable protective gloves is required .
NOTE: Before carrying out any work on the product, ensure
that the rotation direction switch
prevents unintentional switching on .
Install the cutting attachment
This prevents the spindle
[ 24 ]
screw to be removed .
Loosen the screw
PH2 or SL6 screwdriver (not included) .
Remove the screw
Hold the product in an upright position . Swing it gently and
allow the cutting blade
guard (Fig . M) .
Insert a new cutting blade
(Fig . N) .
Ensure the cutting blade
[ 26 ]
spindle (Fig . L) .
Tighten the screw
The attachment is ready for use again .
NOTE: Replacement cutting blades
OWIM .
[ 5 ]
19 ] [
to the product .
[ 26 ]
from rotating and allows the
24 ] [
in a counter‑clockwise direction by using a
24 ] [
from the spindle
[ 25 ]
to slide out slowly from the blade
25 ] [
into the cutting attachment
25 ] [
is sitting tight in the slot of the
[ 24 ]
in a clockwise direction .
25 ] [
is to be removed from or
is in the middle position . This
26 ] [
.
25 ] [
are available from
[ 19 ]
GB 41