Endress+Hauser Prosonic Flow 300 Einbauanleitung Seite 11

2
1.
‣
To reassemble the transmitter version for hazardous areas: turn the
transmitter as far as it will go and then turn it back as far as the securing
screw.
1 →
N ic
P o
S p h t
w e
a n u n
D o n u t e r r
n g
e n n o
e r g
t o ö f f
N e
iz e p e n e
n w n
s o p a d
u s s o h e
t e n u v n
s io r ir
n
I/ O
‣
Align and position the ISEM electronics module in the transmitter housing
in accordance with the diagram.
2
N ic
P o
S p h t w e
a n u n
D o n u te r r
e n n o n g
e rg t o ö ff
N e iz e p e n e
s o p a d n w n
u s s o
h e
te n u v n
s io ri r
n
I/ O
‣
Press down on ISEM electronics module (1) and tighten screws (2).
For detailed information on the electrical connection, see the "Electrical connection"
section of the Operating Instructions for the device.
For detailed information on commissioning, see the "Commissioning" section of the
Operating Instructions for the device.
Endress+Hauser
2.
3.
7 Nm (5.2 lbf ft)
1.
4 mm
2.
0,6 Nm
(0.4 lbf ft)
T10
EA01263D
11