How To Use Advanced Functions; Led Display - Kaisai KCA3U-12 Bedienungsanleitung

How to Use Advanced Functions

Swing function
Press Swing button
Swing
The horizontal louver will swing up and down
automatically when pressing Swing button.
Press again to make it stop.
Airflow direction
Swing
NOTE: When the unit is off, press and hold MODE and SWING buttons together for one second,
the louver will open for a certain angle, which makes it very convenient for cleaning. Press and hold
MODE and SWING buttons together for one second to reset the

LED DISPLAY

Press LED button
LED
Press this button to turn on and turn off
the display on the indoor unit.
2s
Swing
Keep pressing this button more than 2 seconds,
the vertical louver swing function is activated.
(Model dependent)
If continue to press the SWING button, five
different airflow directions can be set. The
louver can be move at a certain range each
time you press the button. Press the button
until the direction you prefer is reached.
louver(Model dependent).
5s
Press this button more
LED
than 5 seconds(some units)
Keep pressing this button more than 5 seconds,
the indoor unit will display the actual room
temperature. Press more than 5 seconds again
will revert back to display the setting temperature.
56
ECO/GEAR function
Press X-ECO button to enter the energy efficient mode in a sequence of
following:
ECO GEAR(75%)
Note:This function is only available under COOL mode.
ECO operation:
Under cooling mode, press this button, the remote controller will adjust the temperature
automatically to 24 C/75 F, fan speed of Auto to save energy (only when the set temperature O
O
is less than 24 C/75 F). If the set temperature is above 24 C/75 F, press the ECO button, O
O
the fan speed will change to Auto, the set temperature will remain unchanged.
NOTE:
Pressing the ECO button, or modifying the mode or adjusting the set temperature to less
than 24 C/75 F will stop ECO operation. O
O
Under ECO operation, the set tmeperature should be 24 C/75 F or above, it may result in
insufficient cooling. If you feel uncomfortable, just press the ECO button again to stop it.
GEAR operation:
Press the ECO/GEAR button to enter the GEAR operation as following:
75%(up to 75% electrial energy consumption)
50%(up to 50% electrial energy consumption)
Previous setting mode.
Under GEAR operation, the display on the remote controller will alternage between
electical energy consumption and set temperature.
GEAR(50%) Previous setting mode
O
O
O
O
57
ECO......