Start-Up; Adjusting The Motion Detector; Setting The Lighting Duration; Adjusting The Sensitivity Of The Sensor - LIVARNO LUX 279890 Montage-, Bedienungs- Und Sicherheitshinweise

ble by turning the nut of the
cable gland.
Connect it with the connection
terminals in the connection box.
Pay attention to the markings
on the terminals
N for neutral and
earth wire) (Fig. C).
Close the connection box.
Align the spot into the desired
direction. For this, you may need
to slacken the screw of the hinge
joint . After alignment, tighten
5
the screw of the hinge joint
again, to ensure a secure hold.
Reinsert the fuse or switch the circuit
breaker back on. Your light is now
ready to use.

Start-up

Adjusting the
motion detector
Depending on the preadjustments
of the motion detector
will switch itself on for a certain
1
period of time as soon as the motion
detector detects movement. These
10 GB/IE/NI
(L for live,
11
for the
, the spot
7
preadjustments are made using the
three controllers on the underside
of the motion detector (Fig. B).
Setting the lighting
duration
Turn the rotary control TIME
clockwise to increase the dura-
tion of the illumination. The
lighting duration can be adjusted
within a time window of approx.
10 seconds to 4 minutes.
Adjusting the sensi-
tivity of the sensor
Turn the rotary control SENS
clockwise to increase the
8
sensitivity of the sensor.
Note: The motion detector
responds to heat radiation. When
outdoor temperatures are low,
it is more sensitive to body heat
than when outdoor temperatures
are warm. Be sure to regulate
the sensitivity of the sensor
over the course of the year.
9