Remote Control; How To Use; Replacing The Remote Control Battery; Operation - Silvercrest SSVF 45 A1 Bedienungsanleitung

7. Remote control

How to use

The remote control 31 is supplied with a
CR2025 (3V) battery inserted. Before
switching on, remove the plastic strip from
the remote control.
Storage
DANGER for children!
Keep the remote control and, if neces-
sary, old and new batteries out of the
reach of children.
Replacing the remote control
battery
DANGER!
There is a danger of explosion if the
battery is not correctly replaced. Re-
place only with the same or an equiva-
lent type.
NOTE: if possible, do not touch the top and
bottom of the battery with your fingers to
prevent dirt from getting on the battery con-
tacts. Use a clean cloth instead, for exam-
ple.
1. Press the small lever on the side of the
battery compartment gently in the direc-
tion of the middle (small arrow), and
then pull the battery compartment out of
the remote control (large arrow).
2. Replace the old battery with a new one.
The positive pole (+) of the battery must
be pointing upwards.
3. Slide the battery compartment into the
remote control 31.

8. Operation

DANGER from rotating parts!
Only operate the fan when all accesso-
ries are fully assembled. The protective
grids 1 and 5 must be closed securely
and undamaged.
Do not insert objects through the protec-
tive grids 1 and 5 while the fan is run-
ning. Keep long hair away from the
rotating parts.
The device can be operated using the but-
tons on the operating panel 8 or using the
remote control 31. Unless otherwise de-
scribed, an acoustic signal sounds each
time a button is pressed.
11
GB