Preparations; Setting Up The Device; Adjusting The Height; Adjusting The Tilt Angle - Silvercrest SSVF 45 A1 Bedienungsanleitung

12. Push the connecting screw 18 through
the two holes and screw on the nut 17
from the back. Make sure that the edg-
es of the two protective grids 1 and 5
are exactly on top of each other.
13. Fold the hinged connections on the front
protective grid 1 so that the two protec-
tive grids 1 and 5 are firmly connected
to each other.
10 GB

6. Preparations

6.1

Setting up the device

Place the device in a suitable location. This
location must comply with the safety infor-
mation (see "Safety information" on
page 4). Ensure that it is stable.
6.2

Adjusting the height

1. Unscrew the circlip 12 a little (anti-
clockwise).
2. Pull the inner pole 11 out of the pedes-
tal 13 or push it in until the desired
height is reached.
3. Screw the circlip 12 back on (clock-
wise).
6.3

Adjusting the tilt angle

The tilt angle of the fan can be adjusted in
steps. To do this, tilt the fan motor 7 to the
desired angle.
6.4

Connecting the device

Insert the mains plug 9 into a wall socket
corresponding to the technical data. A
acoustic signal sounds.