Copyright; Before You Start; Remote Control / Inserting The Battery - Silvercrest SHLF 2000 C1 Bedienungsanleitung Und Sicherheitshinweise

SilverCrest SHLF 2000 C1
WARNING about property damage
 Do not attempt to swivel the unit by hand. This could damage
the motor.
 Do not use any abrasive or astringent detergents.

6. Copyright

All the contents of this user manual are protected by copyright and provided to the reader for
information only. Copying data and information without the prior explicit written consent of the
author is strictly forbidden. This also applies to any commercial use of the contents and information.
All texts and diagrams are up-to-date as of the date of printing.

7. Before you start

Please unpack the fan heater and remove all packaging material. Inspect the fan heater for any
damage. If the fan heater is damaged, do not use it.

7.1. Remote control / inserting the battery

The remote control (19) supplied can be stored in the remote control compartment (7) of the fan
heater when not in use. You can operate the fan heater in the same way from the control panel (1)
of the fan heater or using the remote control (19). The buttons on the control panel (1) and on the
remote control (19) have the same labels and the same function.
The battery has already been fitted into the remote control (19). Remove the plastic strip
sticking out of the battery compartment in order to activate the battery.
If the battery in the remote control (19) is empty, replace it with a new type CR2025 3 Volt battery.
The procedure is as follows:

Press the closure flap on the battery holder of the remote control (19) towards the centre
(Diagram A). Pull the battery holder out.

Remove the empty battery and insert a new battery. Make sure the polarity is correct (+/-).

Push the battery holder back into the remote control (19) until the closure flap clicks into
place.
68 - English