Connecting The Inverter; Connecting The Remote Control - Dometic SINEPOWER DSP612 Montage- Und Bedienungsanleitung

SinePower
8.2

Connecting the inverter

A
NOTICE!
• Make sure that you do not reverse the polarity. Incorrect polarity can
damage the inverter.
• Make sure that the inverter is operated with the following voltage
only:
– DSP612, DSP1012, DSP1512, DSP2012: 12 Vg
– DSP624, DSP1024, DSP1524, DSP2024: 24 Vg
I
NOTE
Tighten the nuts and bolts to a maximum torque of 15 Nm. Loose
connections may cause overheating.
➤ Connect the inverter as shown:
– Connecting the battery: fig. 7
– Connecting the ground terminal fig. 8
– Connecting the 230 V output cable: fig. 9
8.3

Connecting the remote control

A
NOTICE!
Only plug in the connection to the remote control in the remote port.
The device can be damaged by connecting it incorrectly.
➤ Connect the remote control as shown(fig. 0).
8.4 Connecting external switch (accessories)
I
NOTE
When using an external switch, you cannot change the status of energy
saving mode.
➤ Close an external switch as shown (fig. a).
EN
Connecting the inverter
13