Fastening And Connecting The Inverter - Dometic Waeco PerfectPower PP1002 Montage- Und Bedienungsanleitung

PerfectPower
8

Fastening and connecting the inverter

8.1 Fastening the inverter
You can fasten the inverter using the holders supplied.
Note the following safety instructions during installation:
WARNING!
!
 Ensure the device is standing firmly.
Set up the device securely and fasten it in such a way that
– it cannot tip over or fall down
– it cannot move while the vehicle is in motion
 Take precautions necessary to ensure that it is out of reach of
children. Dangerous situations may occur which cannot be rec-
ognised by children!
When selecting the installation location, observe the following instructions:
 Do not operate the device
– in wet or damp environments
– in dusty environments
– in the vicinity of flammable materials
– in spaces where there is a danger of explosion
 Do not expose the device to a heat source (such as direct sunlight or
heating). Avoid additional heating of the device in this way.
 Make sure the cables are the correct length and choose the installation
location near the battery supply.
 Select a well-ventilated location for the device.
A ventilation system must be present for installations in small, enclosed
spaces.
 Make sure that the air intake on the front of the inverter remains clear.
 Select a mounting surface which is flat and sufficiently firm.
EN
Fastening and connecting the inverter
31