Hitachi CP2896TA Wartungshandbuch Seite 65

Operating instructions
Changing the menu language
1. Press the yellow button to select the Vision menu.
2. Press the red button to select the Display set-up menu.
3. Change the menu language with cursor buttons.
4. Press the OK button to store the changes.
5. Press the TV button to exit.
Manual tuning
1. Select the programme number you want to tune.
2. Press the MENU button.
3. Select "Tuning" and press the OK button.
4. Select "Manual tuning" and press the OK button.
5. Press the red button (Channel search).
6. Press the OK button to store.
7. Press the TV button to exit.
APSi (Automatic Programming System)
1. Press the MENU button.
2. Select "Tuning" and press the OK button.
3. Select "Automatic retuning" and press the OK button.
4. To retune the channels, press the red button.
5. Press the TV button to exit.
Initialization of NVRAM
Initialization of NVRAM (ICf2)
In case that the NVRAM is replaced, it must be initialized
and configured.
1. Switch the TV set to stand-by mode.
Press e- (volume minus) button on local control unit
and at the same time start entering password: MENU,
TV and i with the remote control. Release e- button
after the MENU button is pressed. The record led will
light up to indicate that service mode is enabled.
2. Press the RED-button to pre-configure the set. Green
led will flash once to indicate this.
3a. At the same time the controller will check NVRAM
and initialize it automatically if it was "empty".
Initializing will take about 15 s. When it is completed,
the green led will light up. Continue to step 4.
3b. Automatic initialization did not happen if the green
led does not light up steadily. In some cases the led
might also light up immediately after configuration
without any initializing, depending on NVRAM
contents. In this case it might be enough to store the
new configuration by pressing "OK". Continue to
step 4.
Display set-up
Program number
Volume bar
Menu language
Sharpness
Tint
Go back
Menu
Timers
Front panel lock
Locking
Tuning
Sort programs
Programme settings
Go back
Tuning
Automatic retuning
Add new programs
Manual tuning
External units
Copy tuning to VCR
Copy tuning from VCR
Clear all programs
Go back
3c. If automatic initialization did not happen, you can
start it manually by entering the key code: BLUE (wait
approx. 2 s.), 2, 5, 4 (wait approx. 2 s.) and OK.
Initializing will take about 15 s.
4. Switch off the receiver by pressing the mains switch.
5. Start the receiver in TV mode by pressing the mains
switch. Tune in one or more tv channels.
6. Switch off the receiver with remote control.
7. Enter service mode and make the service adjustments
(see section "SERVICE ADJUSTMENTS VIA I
8. Switch off the receiver by pressing the mains switch.
HIDE
SHOW
ENGLISH
Store ª
Press ª
Press ª
2
C BUS").
7