Hitachi CP2896TA Wartungshandbuch Seite 114

Setting up external devices
If you are connecting a VHS video recorder to the Scart E2 connector,
the VCR is ready for use after connecting the cables.
If you are connecting a decoder, see also instructions in the section
"Connecting a decoder".
For other devices, the TV will display settings, which you need to
confirm by following the instructions below.
1
Connect the cables as shown in the illustrations in the section
"Connectors".
________________________________________________________________________
2
Switch on your TV and the device you are connecting.
________________________________________________________________________
3
Press the MENU button (located under the lid).
________________________________________________________________________
4
Select the option "Tuning" and confirm with the OK button.
________________________________________________________________________
5
Select the option "External units" and confirm with the OK button.
________________________________________________________________________
6
Press the red button (Add new unit).
________________________________________________________________________
7
Select the required device from the list and press the OK button.
________________________________________________________________________
8
Check that the device is connected to the connector that is mentioned in
the menu that appears on the screen. Confirm the selection by pressing
the OK button.
Your device is now ready for use.
Changing the input settings
You can change the input settings for any connector. This may be
necessary, for example, when you are connecting several devices or
when the input settings have been changed.
1
Repeat steps 1-5 above.
________________________________________________________________________
2
Select the required device from the list.
________________________________________________________________________
3
Press the green button to display the Change menu.
________________________________________________________________________
4
Follow the instructions on the screen.
Copying tuning information to or from a VCR
If your VCR has the nexTView-link feature, you can copy tuning
information from the VCR to the TV set, or vice versa. The advantage is
having the same tuning information both on your TV and your VCR,
which reduces mistakes in recording programmes.
1
Press the MENU button (located under the lid).
_________________________________________________________________________
2
Select the option "Tuning".
_________________________________________________________________________
3
Select the desired copy function.
_________________________________________________________________________
4
Press the OK button to start copying.
3P58 83041010-GB
External devices
External units
E2 VCR
Select
unit
choose from
alternatives
below
Add new Change unit Remove
unit settings unit
Add new unit
VCR
VCR (S-video) / DVD
VCR antenna input
Satellite
Camcorder
Camcorder (S-video)
Decoder
Game console
Computer
Press
Go back
Change
VCR
Name
E2
Connection
Mode VIDEO
Unit type
VCR
Store
Decoder
Info instruct.
Tuning
Automatic retuning
Add new programs
Manual tuning
External units
Copy tuning to VCR
Copy tuning from VCR
Clear all programs
Press
Go back
29
Go back
»
»
Go back
»